- Nov 21, 2015
-
-
John Crispin authored
Signed-off-by:Stijn Tintel <stijn@linux-ipv6.be> SVN-Revision: 47570
-
John Crispin authored
Update scons to 2.4.1. Signed-off-by:Hannu Nyman <hannu.nyman@iki.fi> SVN-Revision: 47569
-
John Crispin authored
Update cmake to 3.4.0. Refresh patches. Signed-off-by: -
John Crispin authored
* both patches (qcserial/qmi_wwan) were submitted upstream[1,2] * build tested on 3.18 and 4.1 * run tested on imx6 platform with 4.1 1. http://article.gmane.org/gmane.linux.usb.general/132998 2. http://article.gmane.org/gmane.linux.usb.general/133113 Signed-off-by:
Petr Štetiar <ynezz@true.cz> SVN-Revision: 47567
-
John Crispin authored
This patch adds the posibility to config the led behaviour of the lantiq phys over the devicetree bindings.It patches the 0023-NET-PHY-adds-driver-for-lantiq-PHY11G for 3.18 and 4.1. I have also added a register description overview for applicable values. This goes to the documentation folder in the linux kernel. Signed-off-by:Florian Eckert <Eckert.Florian@googlemail.com> SVN-Revision: 47566
-
John Crispin authored
It turned out that mtk_nand driver uses some sophisticated accounting and a general nand code must be patched. This patch adds required read and erase calls to a general nand code. I used a code for re6500 released by Linksys as a reference. All required operations (erase, write and read) are usable. However I found that jffs2 filesystem can be created only on top of a ubi volume. I tried to create jffs2 directly on mtd device but pages with clean markers are became uncorrectable. Signed-off-by:Kirill Berezin <fyiwdt@gmail.com> SVN-Revision: 47565
-
John Crispin authored
All RTC drivers require the kernel to be built with CONFIG_RTC_CLASS=y. Set it accordingly. Tested only with DS1307. Signed-off-by:Helmut Schaa <helmut.schaa@googlemail.com> SVN-Revision: 47564
-
John Crispin authored
This patch improves the default configuration of DWC2 on lantiq SoCs somewhat: * Set maximum packet count to largest allowed value by the DWC2 (511) * Use 16-bit DMA bursts * Divide fifo buffers more evenly Default fifo buffer sizes from original ltq-hcd driver seem really irrational. For example according to DWC2 data book rxfifo size of 240 will not fit even a single full length USB packet. On the other hand non-periodic tx fifo size of 240 is more than enough to fit one complete packet. Change the sizes around to improve the situation and to fix some issues especially with isochronous USB transfers. Signed-off-by:Antti Seppälä <a.seppala@gmail.com> SVN-Revision: 47563
-
John Crispin authored
Signed-off-by:Álvaro Fernández Rojas <noltari@gmail.com> SVN-Revision: 47562
-
John Crispin authored
Signed-off-by: -
John Crispin authored
Signed-off-by: -
John Crispin authored
Signed-off-by: -
John Crispin authored
Signed-off-by: -
John Crispin authored
Signed-off-by:Shonn Lu <countrysideboy@qq.com> SVN-Revision: 47557
-
John Crispin authored
Strigng passed to autoprobing script should match module's name. Currently that string is missing trailing "u". With that change mt7601u driver really gets autoloaded on USB Wi-Fi dongle insertion: ------------------>8--------------- [ 0.930000] hub 2-0:1.0: USB hub found [ 0.940000] hub 2-0:1.0: 1 port detected [ 1.150000] usb 1-1: new high-speed USB device number 2 using ehci-platform [ 1.720000] init: - preinit - Detected arc-sdp // Synopsys AXS101 Development Board [ 1.810000] random: mktemp urandom read with 3 bits of entropy available Press the [f] key and hit [enter] to enter failsafe mode Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level [ 4.940000] procd: - early - [ 5.540000] procd: - ubus - [ 6.550000] procd: - init - Please press Enter to activate this console. [ 7.160000] Loading modules backported from Linux version master-2015-10-26-0-g28c26cb [ 7.170000] Backport generated by backports.git backports-20150903-4-g12cf266 [ 7.200000] cfg80211: World regulatory domain updated: [ 7.230000] cfg80211: DFS Master region: unset [ 7.230000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp), (dfs_cac_time) [ 7.250000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A, 2000 mBm), (N/A) [ 7.270000] cfg80211: (2457000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm), (N/A) [ 7.270000] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (N/A, 2000 mBm), (N/A) [ 7.290000] cfg80211: (5170000 KHz - 5250000 KHz @ 80000 KHz, 160000 KHz AUTO), (N/A, 2000 mBm), (N/A) [ 7.290000] cfg80211: (5250000 KHz - 5330000 KHz @ 80000 KHz, 160000 KHz AUTO), (N/A, 2000 mBm), (0 s) [ 7.310000] cfg80211: (5490000 KHz - 5730000 KHz @ 160000 KHz), (N/A, 2000 mBm), (0 s) [ 7.310000] cfg80211: (5735000 KHz - 5835000 KHz @ 80000 KHz), (N/A, 2000 mBm), (N/A) [ 7.330000] cfg80211: (57240000 KHz - 63720000 KHz @ 2160000 KHz), (N/A, 0 mBm), (N/A) [ 7.470000] usb 1-1: reset high-speed USB device number 2 using ehci-platform [ 7.620000] mt7601u 1-1:1.0: ASIC revision: 76010001 MAC revision: 76010500 [ 7.630000] mt7601u 1-1:1.0: Firmware Version: 0.1.00 Build: 7640 Build time: 201302052146____ [ 8.040000] mt7601u 1-1:1.0: Warning: unsupported EEPROM version 0d [ 8.050000] mt7601u 1-1:1.0: EEPROM ver:0d fae:00 [ 8.050000] mt7601u 1-1:1.0: EEPROM country region 01 (channels 1-13) [ 8.320000] usbcore: registered new interface driver mt7601u ------------------>8--------------- Signed-off-by:Alexey Brodkin <abrodkin@synopsys.com> Cc: Dirk Neukirchen <dirkneukirchen@web.de> Cc: Felix Fietkau <nbd@openwrt.org> Cc: John Crispin <blogic@openwrt.org> SVN-Revision: 47556
-
John Crispin authored
it ends up as $(2) of CatFiles and must be a plain decimal value. Signed-off-by:Günther Kelleter <guenther.kelleter@devolo.de> SVN-Revision: 47555
-
John Crispin authored
Signed-off-by: -
John Crispin authored
The hwid check was wrong, causing the AR71XX_MODEL value to end with a space (as $hwver was unset). Signed-off-by:Matthias Schiffer <mschiffer@universe-factory.net> SVN-Revision: 47553
-
John Crispin authored
r47218 was missing needed changes which were accidentally ommitted from the patch. This should fix #20878 Signed-off-by:Daniel Golle <daniel@makrotopia.org> SVN-Revision: 47552
-
Hauke Mehrtens authored
This dependency is missing for the omap target. Signed-off-by:Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 47551
-
Hauke Mehrtens authored
dwc2_platform.koi is included in dwc2.ko with kernel 4.3. Signed-off-by: -
Hauke Mehrtens authored
Signed-off-by: -
Felix Fietkau authored
Signed-off-by:Felix Fietkau <nbd@openwrt.org> SVN-Revision: 47548
-
Felix Fietkau authored
Signed-off-by: -
Felix Fietkau authored
Signed-off-by: -
Felix Fietkau authored
Signed-off-by: -
Felix Fietkau authored
Signed-off-by: -
Felix Fietkau authored
Signed-off-by: -
Felix Fietkau authored
Fixes QCA99x0 detection issues Signed-off-by:
-
- Nov 20, 2015
-
-
Jo-Philipp Wich authored
Signed-off-by:Jo-Philipp Wich <jow@openwrt.org> SVN-Revision: 47541
-
Jo-Philipp Wich authored
Signed-off-by: -
Hauke Mehrtens authored
This fixes some problems with gcc-5. Signed-off-by: -
Jo-Philipp Wich authored
When fixing the model string for WNDR3700v2 which contain a model string followed by 0xff in r46455, the match for other versions of the WNDR3700v2 which just contain lots of 0xff broke (as the 0xff $model is checked for is stripped off). Fix by stripping off non-printable characters only for the actual output string, but not for the internal matching. Signed-off-by: -
Hauke Mehrtens authored
This backports a patch from upstream u-boot to make it compile with gcc-5. Signed-off-by: -
Hauke Mehrtens authored
Signed-off-by: -
Hauke Mehrtens authored
This backports a patch from upstream u-boot to make it compile with gcc-5. Signed-off-by: -
Jo-Philipp Wich authored
Signed-off-by: -
Hauke Mehrtens authored
gcc-5 handles inline without static differently and that makes uboot-mxs fail to build. Remove the inline so it gets exported and can be used in other functions. Signed-off-by: -
Luka Perkov authored
Removed video related kernel params that are only appropriate for the Freescale downstream vendor kernel and not appriate for mainline linux. Signed-off-by:Tim Harvey <tharvey@gateworks.com> SVN-Revision: 47532
-
- Nov 19, 2015
-
-
Felix Fietkau authored
Signed-off-by:
-
